Author Topic: Workshop manuals?  (Read 1720 times)

0 Members and 1 Guest are viewing this topic.

Brotangp104lyf

  • Here for the food
  • *
  • Posts: 83
  • Gender: Male
  • 19 years on the same p10.....600+k
Re: Workshop manuals?
« Reply #15 on: 18 April, 2017, 02:48:57 PM »
Well, I found the arm, actuator and bracket from the second flaps but cannot see the switch bit that plugs into loom anywhere. So I simply bridged the terminals on loom. Much better! That switch must be a variable resistance type perhaps. By bridging I think its signalling for WOT and adjusting mixture to suit. Smells rich out the back like burn ya eyes lol. Sounds way way better like its being fed properly now. The only way it pings is when you cruise and slightly accelerate under load. Can stop it by stomping to the floor. I figure with no variance on the now bridged switch it can't adjust mixture for revs/ load properly. But it drives! I'm stoked! Theres a knack to driving it to avoid pinging. Easy done till I get the link in. Spanners your the man, thank you. And the others that helped thank you, these di's are a strange one

Sent from my VF685 using Tapatalk

91 p10 x3
P11 x2
Aviner turbo x1
Wrecked n14x1
Fastest di engined Nissan ever 😊

Brotangp104lyf

  • Here for the food
  • *
  • Posts: 83
  • Gender: Male
  • 19 years on the same p10.....600+k
Re: Workshop manuals?
« Reply #16 on: 18 April, 2017, 02:51:35 PM »


Sent from my VF685 using Tapatalk

91 p10 x3
P11 x2
Aviner turbo x1
Wrecked n14x1
Fastest di engined Nissan ever 😊

spannerz

  • Unpaid Subs Members
  • Here for the food
  • *
  • Posts: 91
Re: Workshop manuals?
« Reply #17 on: 06 May, 2017, 11:10:05 AM »
Nice one bro.

Brotangp104lyf

  • Here for the food
  • *
  • Posts: 83
  • Gender: Male
  • 19 years on the same p10.....600+k
Re: Workshop manuals?
« Reply #18 on: 21 August, 2019, 07:21:42 PM »
Just an update, did manage to get it hauling all the way to redline after shorting out the sender wires from the vacuum actuated " secondary " or low rpm butterflies in manifold, running 98, a tweak of timing ignoring the marks and going by ear/feel she runs nice, recently fitted new headers from a ve and better exhaust and she pulls real nice now especially in the midrange. It's actually faster to 100km than my det aviner now lol.
91 p10 x3
P11 x2
Aviner turbo x1
Wrecked n14x1
Fastest di engined Nissan ever 😊